Answer Posted / shrirang
when the induction motor is run above the synchronous speed
the induction motor feeds active power in the three phase line
| Is This Answer Correct ? | 4 Yes | 0 No |
Post New Answer View All Answers
in control panel, how can i measuring the distance between one bus bar to another bus bar. then now only for bus bar. in mpcb and contactor also. that means one mpcb to another mpcb how much distance? how can i calculate that.
what happen ehen synchronisation is done at below rated speed
how can i change the rotation of the AC single phase induction motor and show me by diagram
how will we calculate the copper wire load..
Why power factor should not be in leading (capacitive) mode of any load.
In Air circuit breaker LSIG protection unit is used. Without fault in cables (2 runs 3Cx150Sq.mm Copper, 1Kv grade, XPLE armored cable IR value is more than 550Mohm @ 500V Megger) and load section Long time Overcurrent protection is triggers and trips the unit. We changed LSIG protection with new factory tested unit. Even then fault is persisting. Please suggest the possible causes
what curve and rateing would you use for a three phase 0.75kw motor?
what is mean by PIR in circuitbreaker and give me detail of that?
hi i will D.E.E.E.is completed pls send rrb diploma old qustion papaer sent in my e mail. i.d.
how can service sitting be setted for MCCB?Example for sittings IR (CURRENT RATING),IS(CURRENT STARTING)IO (current operating)?
what is the reason the main breaker is trip during the motor is running? (some time the breaker is not trip)
what is the affect of earth's magnetic field on the frequency used in aircraft???
static chagre
What is the effect on power factor, shown by a trivector meter; incase of reverse phase sequence. If the power factor of a system is lag what meter will show in case of reverse phase sequence connected to the meter. and What in case of lead.
what are safety measures in /control in diesal engine/ explain them?