Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / guest
voltage drop =current x resistance
| Is This Answer Correct ? | 0 Yes | 6 No |
Post New Answer View All Answers
How do I calculate/select Droop CT ratio for various capacity of generators?
In 90 kva alternator that produce the output voltage is 115(p-n),200(p-p) at 1500 rpms means what ampere it produced ?
What are the advantages of using distance protection schemes as opposed to normal overcurrent/ earth fault protection on high voltage feeders.
What is meant by a stray loss of a induction motor??? What is the equation to find it
details of oil cell size of Breakdown voltage test of tranformer oil details as per Standardswith mushroom electrodes?
why only exciting current is shown not primary current in transformer???
My question is whether bellow formula is correct to find bus size for 46kA for 0.5 second & what is RT in bellow formula. formula to calculate the size of busbar to withstand the thermal stresses due to currents with duration of 0.2 sec to 5 sec. Sp = RT( I x I x t) / K Where Sp – is the cross sectional area of bus bar in millimeters. I - is the value of AC fault current. t - is the operating time of disconnecting device in seconds. K – is the factor depending on the material of the conductor, insulation and initial and final temperature. Value of ‘k’ for copper is 143.
A 2083kva AVR was tested, phase to ground shows continuity, what is the implications
any body,pls tell me how to done relay coordination ? how to coordinate by TCC curve?how to read the tcc curve?
electromechanical relay type identification example : type=tjmh t-stants for j- m- h-
What is the difference between PLC and Embeded system
what does a k rating in a transformer means?
For refrigerators the motor current is raised beyond its rating on both conditions when the voltage of the system is more(say 270v) than the rated voltage(220v) as well as when the voltage of system is less(say 160v) than normal voltageof 220v, why explain?
Please send 110 kv sb station full single line drawing(sld)
How cable from Kit-Kat to main switch, from starter to motor are designed?
