Golgappa.net | Golgappa.org | BagIndia.net | BodyIndia.Com | CabIndia.net | CarsBikes.net | CarsBikes.org | CashIndia.net | ConsumerIndia.net | CookingIndia.net | DataIndia.net | DealIndia.net | EmailIndia.net | FirstTablet.com | FirstTourist.com | ForsaleIndia.net | IndiaBody.Com | IndiaCab.net | IndiaCash.net | IndiaModel.net | KidForum.net | OfficeIndia.net | PaysIndia.com | RestaurantIndia.net | RestaurantsIndia.net | SaleForum.net | SellForum.net | SoldIndia.com | StarIndia.net | TomatoCab.com | TomatoCabs.com | TownIndia.com
Interested to Buy Any Domain ? << Click Here >> for more details...

what is name of transformer oil ?

Answer Posted / a.bhanu chandar

Transformer oil is nothing but it is a "pure hydrocarbon mineral oil"(the colour of oil is "pale-yellow colour").
1)It provides "insulation and cooling".
2)It is free from moisture(Due to moisture..the dielectric strength will be decreases,for avoiding moisture we use "silica gel breather")

Is This Answer Correct ?    0 Yes 1 No



Post New Answer       View All Answers


Please Help Members By Posting Answers For Below Questions

why we need to us lenz's law for synchornous motor

2624


where the lexical paramater will use in fron end?

1926


What type of a DC motor would you use for a lift?

1121


how to determine Sq.mm size of finolex power cables.

2046


what will happens if one phase is missing for 33/11kv power transfomer and why?

2710


When can we take Neutral as common neutral link?

1715


what are symmetrical and non symmetrical components in electrical installation.

2130


Different STANDARDS (BS, IS, IEC etc) gives different informations on CT specification. How they correspons w r t each other (i.e I mean to say BS provides "knee point voltage" but IS does not, then how can i select CT)

2010


What will be the current drawn by HT motor, if low voltage is applied.. any formula to calculate the LT amps of HT motor.?

1506


why i can not use thimble on capacitor duty contactor

1398


What is meant by bus bar protection?

1257


We are preparing another project which involves Waste heat recovery from a 1 MW GE Engine. The Engine in particular gives out flue gas at 487Deg C with a flow rate of 5650 kg/hour and this can be cooled to 180 Deg C. This gives a thermal output of ~ 594 KW that is available for input to VAM via heat exchanger / boiler. Additionally 581 KW will be available from engine jacket water (temperature profile 80/ 80 Deg C and a flow rate of 50m3/hr) Our estimation is that 300 TR of cooling is possible with a suitable VAM machine(s). Please advise what is the most suitable arrangement with maximum TR and min Capital expenditure. plz reply me as early as possible

2039


how to store the thunder power?

4575


What is power relay?

1298


What is MS-EXCELL?

2297