Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / bf chauhan
Basic difference is that PLC have 2 software for operation
one is SCADA Software and other is Programming software
while DCS has only one software which work as programming
as well as graphic building.
Also PLC mostly used where descrete IO are more and Analog
IOs are less while DCS are preferred where descrete IOs are
less and Analog IOs are more.ie. DCS is more suitable where
no. of closed loop are more.
Also DCS has have greater flexibility than the PLC.Analysis
of the process and report generation is better in DCS
compared to PLC.
| Is This Answer Correct ? | 4 Yes | 0 No |
Post New Answer View All Answers
why we are using magnet for calibration of gas detector?
We Have Two Field bus Pressure Transmitters of Different Sensor Range (I.E One is of Lower range and Another is of Higher Range).Is same Process Line. My Question is Can i provide Saturation Limit to my field Bus Transmitter as We can provide Saturation current limit to HART Instruments. As During Low Pressure Both Working OK ,But During High Pressure, transmitter with Lower sensor range Goes to Fault mode as Beyond its Sensor Limit it can Measure, So may I provide Saturation point Some where to Suppress This Fault during High Pressure.
what are procedure of sox-nox calibration
Why thermo wells are used? What materials are used in thermo wells?
Boolean algebra
all types of liquid analyzer principle with drawing?
What is 3 selection available when configure the burnout protection for controller
What is frequency factor in massflow meter? When using frequency output?
what is diffrance between FF & SMART, explain with difination
how to work MIL contol valve posistioner ?
Somebody tell me in what way i need to prepare for csio pgrpe(adv instrum eng)interview?what all the quest can i expect?
How digital input and digital output 's are working in dcs
What is the PLC configuration in Cement industry?
what is easiest way to read STL language in PLC?
I have a Control VAlve having size of 2 ".Only the known parameter is Pressure drop . Its 2 Kg. Then How to calculate control valve sizing means Cv.
