Answer Posted / er palanivel

M40 IS STRONGEST BECOZ IT CAN DO 40 N/MM2 CARRING LOAD

For sloping slabs or sloping beams why the tension steel from either side of ridge is taken into compression zone of other side?

2224

---

Tell me about triple point of water.

1119

---

What is type failure of road surface? how to repair the failure of road surface?

2483

---

asubmerged weir is one in which the water level on the down stream side of the weir is just at the crest level below the crest level above the crest level at stamp elevation as water surface on upstream

1945

---

A super elevation of 60 cm has been provided on a 8m wide road and a curve of 260m radius .calculate the max.speed in km/hr of the vehicle that can be negotiated safely? Plz answer with full solution.thanx

1819

---

How do you compute the volume of airflow?

1110

---

plumbing CPVC fitting FTE Brass full form

2697

---

In the design of bridge arguments what considerations should be made to select the orientation of the wing walls?

1084

---

Pls explain me about tension and compression in a flat slab

2029

---

What happens when,in Prestressed girder the HDPE duct and cone size is provided more than required? (technical answer expected)

2115

---

what is the water cement ratio? how to calculate it? list the wt. of constructions materials including concrete both ordinary and light wt. concrete

2302

---

I used Etabs software to analyse a high-rise building. And I want to use templated UBC-codes inside to calculate the Seismic load. My question is: whether or not I have to control the seismic load by base shear load which is manual calculation? (just for more clarification: I can control this by input the scale factor into Eartquake definition in Etabs) I would highly appreciate your answer.

6085

---

reinforcement slab, beam and column formulas?

2677

---

how we check the thickness and line of ceiling plaster.

2668

---

How many are the types of joints?

1195

---