Answer Posted / pritesh
arcing can be done by breakdown of dielectric strength bet two contacts
Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
Batteries used for electrical energy storage are a. Laclanche cells b. Edison cells c. Lead acid cells d.any of the above
What conditions are required for transformer to operate at low frequencies ?
After taking shutdown of 11kv feeder, if you see 5kv by phasing stick in the cable side, is it possible to close earth switch in cable.
why are u join ntpc
i have total 8 dg sets for synchronizing and 2 buscoupler,1 sectoin dg no 1,2,3,and 2 sectoin dg no 4,5,6,and last section dg no 7,8 ....if buscupler no 1 and 2 is off mode ..than dg no 1,2,3,will synchroniz of another dg sets?
Ac generato how produce power I need for camplet defination
If I want to lift the water at a height 50m from ground level through two inch(diameter) metal pipe then what is the capacity of motor pump is required? is it possible in single phase supply or not?
why we cannot protect 100% winding of an alternator by using differential protection?
what is the purpose of slope in the differential relay?why we are using two slope?but in busbar differential we are using only one slope.why?
what is the illumination level required for child play area?
Sate maximum power transfer theorem?
what are the preventive maintanance actions taken for air circuit breaker? please answer me
What are IP protections used for electrical panels, JB, equipments installed in explosive zones like Petrochemicals, Oil & gas
Do closed loop systems require manual input?
we use 400/5A ct and 35/roor3KV,/0.1/root3KV,0.1/root3KV pt ratio. What is the multiple factor of this meter.