Interested to Buy Any Domain ? << Click Here >> for more details...
Why Bently Nevada use negative voltage for vibration probes?
- 4 Answers
- 20192 Views
- I also Faced
- E-Mail Answers
Answer Posted / taha
to generate frequency required -24v as minimum
| Is This Answer Correct ? | 6 Yes | 5 No |
Post New Answer View All Answers
Why use ball valves on Gas pipelines instead of gate & or globe valves...means basic diffrence or use of these valves..how designers knows this type of valve with rating is required...
pls provide me syllabus and old question paper of instrumentation engineering for GET(JSPL)
What care will you take in the installation of control valves,SCADA,DCS and FOC in Oil and Gas Project?
I m appointed as an automation trainee engineer in small firm in that I am only the one , my company give me a project on s7-200 as i m beginner I don't know how to program so please send me the helpful site so that I complete my project before deadline....please help me out in this critical situation.
1.can you use SCADA instead of DCS,DCS instead SCADA 2.Difference between DCS and PLC,can their role be reversed i.e. role interchange 3.Difference between RTU and PLC
(1) In turbine, what does term CDP, NI, NH, HSSOC, means. (2) What is the purpose of LO overhead tank in turbines.(3) An equipment is certified for EEX, IA, IIC,T6, what do you under stand by this.(4) what is SURGE, and how it is prevented, what is the purpose of bypass valve across AS valve.(5) Give 2 application of quartz crystal used for process parameter measurement.(6) what is meant by cold float of compressor shaft. (7) state four different types of flow measurement. For gas flow measurement mmscfd is the common unit. Expand the unit and specify significance of word S in the unit.(8) what is meant by Gap voltage, in vibration measurement. Normally how much Gap voltage is set and state the reason.(9) what will the new flow factor if D/P transmitter is Re-Ranged from 25” wc to 50” wc.(10) what is the usage of QDV & Volume booster.
Difference between ultra sonic flow meter
We Have Two Field bus Pressure Transmitters of Different Sensor Range (I.E One is of Lower range and Another is of Higher Range).Is same Process Line. My Question is Can i provide Saturation Limit to my field Bus Transmitter as We can provide Saturation current limit to HART Instruments. As During Low Pressure Both Working OK ,But During High Pressure, transmitter with Lower sensor range Goes to Fault mode as Beyond its Sensor Limit it can Measure, So may I provide Saturation point Some where to Suppress This Fault during High Pressure.
Explain the working of rota meter.
what is commisioning procedure,2)what is is the main work in commisioning in the field tx to dcs, plz send me detail
How hart protocol can be connected with control valves?
Make a ladder diagram on LSL valve will close, on PSL valve will open and start the motor
List three types Level Switches with their working principles
when placing a vent or drain hole on an orifice plate should you measure from the center of the bore up or down for the vent placement?
How to change dcs card in online. (Dsc is maxdna)
