Answer Posted / adam
1-earthing
2-Safety Switching Mechanisms like ELCBs..ets.
3-Warning and Notices and proper labeling .
| Is This Answer Correct ? | 4 Yes | 0 No |
Post New Answer View All Answers
briefly explain principle of resistance welding
in control panel, how can i measuring the distance between one bus bar to another bus bar. then now only for bus bar. in mpcb and contactor also. that means one mpcb to another mpcb how much distance? how can i calculate that.
why occ characteristics curve in not tracing back when we are bringing back the rhoestat?
Is there any relevant technique to produce power from light and heat energy of the sun simultaneosly from same rays of light?
what is a composite error in current transformers, why occurs & in which it will occur i.e, either metering ct/ protection ct
Wind mill
How to calculate Ith (I thermal) for curent transformer
if a number of plc s are there then how many modbus to be used
How can we find out LT UG cable fault (size,from-4*25mm sqr to 4*300mm sqr)? How mani types UG cable faults?
DG cranking voltage?
I have experienced electrical maintenance HT ,but I completed be ECE ....can I apply c license or not ???? Pls help me friend s...
how to calculate units consumption for a 12 hp motor /hr.
How to calculate or formula to calculate rhe power in 2 phase system ??
can anyone explain the star-delta motor control wiring ,which wire go where and how they operate?
WHAT DO YOU MEAN THE DIFFERENT TYPE OF CURVES OF RELAY LIKE STANDARD INVERSE, VARY INVERSE, NORMAL INVERSE, LONG INVERSE ETC....
