Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / g pravin
An annubar is a flow measurement device,which is used to
measure the flow of liquid in a pipe at low pressure high
flow rate.
| Is This Answer Correct ? | 2 Yes | 8 No |
Post New Answer View All Answers
To become an Instrument DESIGN engineer, is there any softwares or training to become Instrument Design engineer, plz suggest me, Iam very much interested in designing.
please send me the inteview questions in IOCL
There are many type of control cable like pair,core,tried, What are defination each one
Explain the working of an electronic level troll.
how to calibrate and troubleshooting of leveltroll?
1.what is the effect of vapour presuure in orifice plate flow measurement 2.which is more effective 2 pressure sensors or one single differential pressure sensor in orifice plate measurement 3.how to design a v/i converter and i/v converter 4.how many type of thermocouple are there 5.how many leads are there in thermocouple measurement 6.how pressure sensors are connected in level measurement in differential pressure method 7.what is the output of capacitive pressure sensor (ac or dc),how its o/p is signal charactarized 8.what is the physical meaning of discharge coeeficient,why it is calculated,orifice plate what is its value,why it is less than 1,Q at upstream is equal to or not equal to Q at downstream of orifice plate why?what is vena contracta in orifice plate 9.why rotameter is called variable area flowmeter,it can measure flow even if area is not varying,why it is made tapered 10.design a 10 bit counter ,which counter you will prefer 11.how to remove self heating error in RTD 12.which is more sensitive pt100 or pt50 13.why thermocouple are connected in parallel 14.what is lead contact error in RTD,how to avoid 15.what is P,PI,PID,PD controller,why there is no ID controller 16.what is override,split range,sequential,ratio,feedforward,cascade controller 17.why we moved from SR to JK and then JK to master slave JK flipflop,give correct reason 18.how to measure level of a closed container which contains vapour and liquid,remember no vapour gas should be leaked,so ultrasonic and capacitive is not an option,design another method 19.how to design horse race counter including sensors and signal conditioning element 20.what is bevelling
What is the function of solenoid valve in on/off & shutdown valve and why it is not used in control valve normally?
how can i check vortex shedder bar it is ok? if there is ohms condition are shown correct?
OBJECTIVE TYPE QUESTIONS OF ANALYTICAL INSTRUMENTATION
What is the difference between modbus,fieldbus & profibus
Somebody tell me in what way i need to prepare for csio pgrpe(adv instrum eng)interview?what all the quest can i expect?
give some question relative instrument fitter?
can u plz send me technical questions asked in SCHNEIDER ELECTRICAL technical paper?
In bently nevada vibration monitoring system,what is the reason to maintain the Resistance of the probe + extension cable equal to 95 ohm? If possible explain the basic principle of measurement with detail electronic circuits.
selection of the zener barrier for the hazardeous area zone 0
