Answer Posted / shashank saxena

Actually basic difference is in Construction part.

In ceiling fan stator winding is done on inner part ie. the ceiling fixing rod, and the rotor winding is done on outer side ie. on main body of the fan.

In case of table fan, stator winding is done over the rotor winding, ie. Rotor winding is done on Shaft, which rotates under the influence of the magnetic field of Stator winding.

One more difference is-
In ceiling magnetic flux is outward while in table fan, magnetic flux is inward.

What is the permissable nutral current of three phase system as per IS standards?

2093

---

Why we find the sensitivity for the CT's to check?

1846

---

What are the properties of a resistor?

1097

---

how you will decide the distance between the power transformer and its fencing

1951

---

please send me privious exam's queation papers of section engineer(electrical).

2050

---

What is voltage divider rule?

1170

---

Explain marx circuit.

1322

---

What is the different types of cable & current capacity of cable

1938

---

How to calculate the size of earth cable to earth the neutral of UPS ?

1918

---

how to build a network which step down 415v to 1v rms

1972

---

Which cable is use for rtcc control panel

1749

---

in ACB breaker requireding 3200Amps. buscoupler getting OFF mode and again it reset and getting normal position give me a required answer?

2325

---

15hp motor wound by 0.9mm & 0.95mm magnet wire. at no load test it draw 4.2A current. Another motor with same condition draw 9.2A current. How can that occur? pls help

1557

---

what are the assumptions made in swineburne's test?

2154

---

I am about to write exam in RRB bangalore for the post of section engineer.please provide me with previous exam questions

2138

---