Interested to Buy Any Domain ? << Click Here >> for more details...
what is the pre commissioning test to be carried out on LT power panel at site?
- 1 Answers
- 13590 Views
- I also Faced
- E-Mail Answers
Answer Posted / arasusulo
checking the all of bus
bars tightness and visual
short at phase to phase and
neautral...
then megger the separate
phase and ntral bus too.
then circiut braker
condition tooo.then charge
the supply and check ph
voltage and line voltage.
switch on the braker then
dstrbt the suppply by the
feeder what it is..?
| Is This Answer Correct ? | 19 Yes | 1 No |
Post New Answer View All Answers
A 3-phase IM is supplied from 50 Hz system. It runs at speed of 1440 rpm and slip equal to 4 %. Calculate number of pole pairs. A 1 B 6 C 2 D 3
How dia computation perfomed in cold rolling mills .
how many Classification of fire extinguisher
In a Impedance Based Distance Relay (Quad Characteristics) - Could there be two different Line Angle(RCA) for Ph-Ph & Ph-Gnd? If So Kindly Let me Know.. Where, What are the advantages of the same?
Why delta star trformers are used for lighting loads?
What is the difference between the relay and the circuit breaker?
Why the efficiency of generator is more than motor in swinburne's test
what is a speed of rotor when we give supply to stator of 50hz and as well as rotor of 60hz of an induction motor?????
Why do we pefer VCB over OCB?What are the advantages of VCB over OCB?
1))why we run three phase or three different circuit from a single conduit 2)) why not two circuit of different phase run in same conduit?? and why we run same three cicuit of same phae run in single conduit??
What is slip in an induction motor?
please send the last 5 years {{{JUNIOR ENGINEER - ELECTICAL, ELECTRONICS RRB CHENNAI and secundrabad}}} TECHNICAL question papers TO MY EMAIL ID dinesh100701@gmail.com
please give some hindalco placement papers for written exam
what is the use of permanent magnet generator in exciter
What is excitation in case of dc motor?
