what is the difference b/w wet leg & dry leg level method
Answer Posted / rohan murkar
The difference is ,In wet leg level.a condensate pot is
attached to txr LP side.Thus pressure also acts because of
the condensation of process liquid on the LP side of txr.So
we have to consider that pressure while calibration.
| Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
Draw a complete P&ID of a flow suction tank indicating all control & protection equipment. Indicate all its inlets and outlets. Explain the controls for this system
how to convert cubic metre per hour to newton cubic metre per hour
what is the difference between -24 : +24 & 0:24 and where it use?
what is span value and zero ? and how set ?
In turbine what does term CDP, NI, NH, HSSOC means.
Calibration procedure for Electro magnetic Flow meter
all types of liquid analyzer principle with drawing?
What is zero elevation and zero suppression?
How oil line flow measured?eplain about instruments used and working principle?
How earthing can be checked????
how to calculate range of level transmitter?
I am having a Phoenix digital to modbus converter. The o/p of the same is connected to flow computer FB407. But the digital signals are updated only after one minute in the flow computer. what may be the cause of delay in communication? Flow computer is having a scanning period of less than 1 sec.
Explain the mechanism behind the turbine meter.
In my company plc based winders are operated. one day there was a data transmission failure alarm shown on pc. as per sir instruction we have reset master plc but winders were not triped and alarm gone. so what master plc do?
can anyone can let me know in Eurotron Micro cal 2+ calibrator in milli amps source mode we are not able to get 20 milli amps output it only produces 1.52 milli amps out, but display shows increase in milli amps , and err6 displays, let me know how to remove the err 6.