Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / raghib haidar
it is primary element measure for very low flow
| Is This Answer Correct ? | 10 Yes | 9 No |
Post New Answer View All Answers
Explain the difference between mmwc and mmwg?
A PLC is programmed to drive three motors A, B and C as follows : After running motor A for an hour, motor B should get ON and motor A should get OFF. And after running motor B for an hour, motor C should get ON and motor B should get OFF. And after running motor C for an hour, motor A should get ON and motor C should get OFF. (That is, a cyclic repetition with time period one hour) Now, the second condition is: If any motor gone faulty and is tripped, the consecutive motor should get ON and the faulty (tripped) motor should be eliminated from cyclic repetition. The remaining two motors should bear the cyclic repetition of one hour each. (For healthy motor take logic as high and for tripped motor take logic as low) Now, the third condition is: When motor A load(Amps) exceeds 60% of its rated load, motor B should get ON in parallel to motor A. And when both motors A & B are running in parallel, and if their load exceeds 60% of their rated load, motor C should also start in parallel to A & B. [Here the cyclic repetition is eliminated, until their loads become normal(40%)] [Take logic high(1) for load at 60% and logic low(0) for load at 40%] Now draw a flow chart or a ladder diagram to fulfill the above condition.
How do you identify between actual alarm and false alarm in a Temperature Transmitter in SCADA based Control System
a flow transmitter [range-0-400mbar] connected in process line. please explain me how to calibrate the flow transmitter , & how to do static error
Can I route 110 VDC and 24 VDC in a same Duct for our Interposing relay cabinet? IF yes or NO Please provide me IEEE Std. for the same. Please i required it on Urgent basis, i need to design IRP Cabinets and we have MCC 110VDC and Our Coil side is 24VDC, Please help as soon as possible.
what is the difference between magnetic flow meter and mass flowmeter
what is metal of piston ring
what is o2 analyzer and how it measured ,what is the role of this analyzer in cfbc boiler...
I have 0.75mm sq multicore cable (IS type) , can use instead of same type but 1.5 sq mm cable ? Note : The distance is around about 150 meter.
Explain signal isolator
while am calibrating Drager polytron 2IR flame gas detector occured non zero status.how can i get zero status?
Why ac supply load cell is used? Can we use the dc supply load cell?
Name different parts of a pressure gauge.
where i can get training in INTOOLS and PDMS in Delhi-NCR OR north part of India. please reply with ur ans. at arunsamkaria@ymail.com
i want to find out iffco get test paper
