Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / tarun aggarwal ymca
CYWY is cable
C= copper Conductor
Y =PVC Insulated,
W =Galvanised Round Steel Wire Armoured
Y =PVC Outer Sheathed
So it is a copper Conductor, PVC Insulated, Galvanised Round Steel Wire Armoured and PVC Outer Sheathed cable
| Is This Answer Correct ? | 16 Yes | 1 No |
Post New Answer View All Answers
why electron produce magnetic field when it is in motion?
Dear all, how we select the cable size according to current with or without including different correction factor , is there any direct method for sizing of cable...
How to calculate KVA/VA rating of PT or CT from primary & secondary voltage or primary & secondary current?
what material is used in capaciter
1. The DC generaror,s induced output emf is connected with a DC motor(as load). when increasing the load of the motor by using brake drum or any way. what are the parameters will changes in both motor and generator(voltage, current, resistance, frequency, speed, torque, power, flux etc...) 2. Similarly for AC generator and AC motor 3. similarly if using DC batteries instead of DC generator, What happens?
While performing stability test of differintial cts how to know the voltage and current on both side of the transformer?
why the NGR (neutral grounding resistor) always OFF during DG off?
In Power Line Communication (PLC) the wave trap is used to block communication signals from entering neighboring lines. My question is this: Why do they allow for different filtering arrangements on these wave traps? Isn't it always going to be a low pass filter since we want the power frequency to go through, and the comm signal blocked?
Why to keep capacitor bank off while generator running.
What is the difference between diode and a transistor in terms of the direction of current flow?
what happened when we supply a dc current in dc motor?? can it worked properly?
What is the difference between relays and contactor construction wise?
stand by earth fault protection (51G) for transformer rating 2000 kVA,Dyn11,33/0.400 V. LV NCT ratio and necessary resistor and metrosil values how to calculate
if the number of poles generated in stator and rotor side of an induction motor are different then what will happen and why?
If any cable burnt how can we identify it burnt by high current of high voltage?
