What is the difference between "working stress method"
And "limit state method"?
Answer Posted / anjali
• In working stress,Stresses in an element is
obtained from the working loads and compared with
permissible stresses.The method follows linear stress-
strain behavior of both the materials.Material capabilities
are under estimated to large extent.moreover Ultimate load
carrying capacity cannot be predicted accurately.
• Whereas in limit state method, stresses are
obtained from design loads and compared with design
strength.In this method, it follows linear strain
relationship but not linear stress relationship (one of the
major difference between the two methods of design).The
ultimate stresses of materials itself are used as allowable
stresses.The material capabilities are not under estimated
as much as they are in working stress method. Partial
safety factors are used in limit state method.
Is This Answer Correct ? | 69 Yes | 4 No |
Post New Answer View All Answers
How to make a c++ program that converts any base to base 10?
we want build 10ft height ,tostore 4 litresof water.what is theground basement for steel andcement andsand.please send us basment calculation?
what is pouring and explain
What is the Tor steel Consumption for residential building G+24 footing (thum rule) ?
what is the percentage of silt in black cotton soil.?
what is directivity effect?
how to calclate the SHUTTERING TAKEN CONCRETE LOAD? WHAT IS THE LOAD BEARING CAPACITY IN STEEL SHUTTERING PLATE? WHAT IS THE CONCRETE LOAD IN (MASS) IN THE SHUTTERING PLATE. PLATE SIZE IS 120CM* 90CM CONCRETE WALL LENGTH IS 10M ,WIDE IS 60CM, HEIGHT IS 1.2M PLS TO SENT THE CALCULATION.
WHAT IS THE % OF CONCRETE WASTAGES PERMITED IN A LARGE PROJECT ? AND WHICH IS CODE TO BE REFERED.
What is the yield of 100 litres of water and 10 kg of cement in grout mix?
What is the difference between linear dimension and aligned dimension?
what is the code provision for acceptance of fineness modulus range for fine aggregates in design mix
how to calculate 1:5:8 ratio concrete cement, sand, metal and water please give me brief calculation
what isload waring calculation
What is the difference between undo & redo?
what is the amount of absorption of slurry in shuttering ply board. what is the amount of slurry leakage allowed for 1 m3 of concrete.