Interested to Buy Any Domain ? << Click Here >> for more details...
Bus-bar is made of which material & name of mostly used
material in bas-bar design ?
- 7 Answers
- 26923 Views
- I also Faced
- E-Mail Answers
Answer Posted / s.venkatraman
Alu r copper. most company used to alu only
in case load is high increase bus nos r size
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
what is relation between ct and pt ratio with multiplication factor of a energy meter? is there any other factor on which multification factor depend?
Why is the starting current high in dc motor?
what is mean by NPS (Negative phase sequence)fault? what is the difference between EFR & OCR faults?
we have earthmat at 110KV substation.we would like to take earth resistance.b some says that by connecting earth megger terminals (C1,P1) at middile point of earthmat (at riser) will cause voltage gradient at other earthmat nods and dont get exat earth resistance.when connecting at end nods will get exat value . is it correct .please explain
What does ampere turns shows?
What is George phenomena to start the synchronus machine?
In india, according to trade theory above 5 HP motor reqired star delta starter. But we R connect 11 KV motor with 14MW in Direct to line ( With VCB starter combination) Can U Guess, How it is possible ?????
hello friend i wish to study a course related to the electrical construction, controlling and monitoring , which course i want to study? pls give me the name of institute?
HOW TO CHECK THE VECTOR GROUP OF A TRANSFORMER YD11?
limitation of conductor height on ground when we consider EMC
How to address the servo drive for motor
what should be the no load current for 3 phase ac motors ranging from 5 kw to 1000kw?
A commercial Building is designed with 14th floor levels with indoor substation of three phase transformer with rated capacity of 1000 Kva.The transformer delivered 65% of its rated capacity at 0.67 power factor lagging.Because of low power factor, the power customer was penalized and certain cost was charged accordingly based on every point percentage lower than 85%.This situation may repeatedly happen on the succeding energy bills of power customer.The power customer is desired to improve its historical power factor of 0.67 lagging and no further penalty be impose by the local power company on the next bill. Q: Identify the appropriate solution you want to offer to Client?.Justify SCIENTIFICALLY and MATHEMATICALLY the principles behind the solution.
What is Percentage impedence of a transformer? why it is expressed at a percentage? what is the importance of percentage impedence in case of a transformer?
How many kinds of E.L.C.B and how to work E.L.C.B
