Interested to Buy Any Domain ? << Click Here >> for more details...
What is the difference between Split ring and slip ring?
- 8 Answers
- 37223 Views
- I also Faced
- E-Mail Answers
Answer Posted / sparsh srivastava
Split Ring are in A.C Generator while Slip Ring are in D.C current.
| Is This Answer Correct ? | 6 Yes | 50 No |
Post New Answer View All Answers
please tell me how a surge protector work on a DC 48Volt.? please describe briefly.
How to decide the size of the capacitor for a single phase induction motor say 2 HP ??
In our plant we have installed new MCC with ELR and CBCT which is detecting some leakage current in the system but it leading to some confusion when to check that in which feeder which is drawing current we put off the whole panel itself but still CBCT detecting some leakage current so can anybody ans me , where i am going wrong or how to detect whether its actual leakage or CBCT malfunctioning.
What is the fault or needs to be done when frequency in ac drives is not changing?
who many types of fire explane with exmple
Define non-touching loop.
Can we use BS 6651 and BS EN 62305 standards for computer room lightning ptotection in substation?
which capacity of RCCB used for five thousand watt electricity load?
Why use in ht motore
Whats the minimum value for I.R. that can be allowed for HT & LT alternators for operation?
1. A 380 / 220 V r.m.s. 3-phase 4-wire circuit carries loads of 8 + j8.1 ohm; 4 + j4.1 ohm; and 2 +j2.1 ohmin the three phases respectively. The length of the circuit is 100 m, and the resistivity of the phase conductors is 0.0005 Ω/m. The neutral conductor is of the same size as the phase conductors. a) Select a reference angle 0for the first phase. Then write down the three phase voltages in both polar format and complex number format. b) Make appropriate assumptions, and take temperature effects on resistance is insignificant. Calculate the currents in the three phases. (Note: Determine conductor resistance, and apply Kirchhoff’s Voltage Law) Based on the result, suggest a main switch rating for the circuit. c) Show your preferred direction of neutral current in a diagram, and then determine its value. (Note: Apply superposition principle, and Kirchhoff’s Current Law) Use its magnitude to show that in this circuit, the unbalanced load may increase the voltage drop in some of the phases. (Note: Also observe the common volt drip in neutral) State your assumptions, if there are any. d) Suddenly the neutral wire of the circuit is broken. Estimate the new currents in the first phase, i.e. Phase L1. State your assumptions, if there are any.
ult of expression 'document.FrmQF.myem
What we mean by vintage of an engine+Generator?
How we can calculate the Amps for the cable Ex:- For 1sqmm wire how many amps we can draw (calculation)
there is an alternator 480 k.w, 400v,50hz, 4-wire running on load having leakage alternator body earthed current 38 A. is it within acceptable limit? if yes then give reference if no then how to bring within specified limit
