Answer Posted / sajin
concrete setting is a chemical reaction called hydration,for hydration the presence of water is required.after the placing and finishing of concrete the water will start to become dry because of hydration and evaporation due to atmospheric temperature ,so we need to pour water on the surface of concrete and to cover the concrete with some rug or plastic sheet to reduce the water loss. the process of keeping the concrete wet until it set is called curing..
Is This Answer Correct ? | 7 Yes | 2 No |
Post New Answer View All Answers
How to calculate quantity of plum masonry in 1:3:7
how statics is different from dynamics
what should be the PCC ratio to construct a plinth of (40x40x4)ft...??also its estimated cost??
What is a hatch patterns?
HOW MUCH STEEL REQUIRED FOR SLAB OF AREA 23'3"*18.3"? FOR SLAB HOW MUCH DIAMETER BAR WILL USE?
TELL US ABOUT A TIME WHEN YOU FAILED TO MEET A DEAD LINE. WHAT WERE THE REPERCUSSIONS?
What should be the lap length in raft if height of raft is 0.800mm ...it couldn't b 50D or 40D...we just have to join upper and bottom reinforced...is there any formula for determine it...
Will going from a 3-tap to 6-tap increase water pressure?
explain the advantages of total stasion
For a washout valve why are two gate valves required in normal practice?
why we are using stub column..? is it possible to construct steel stub column..?
What things you need to take care of before building a kitchen island?
What is geopolymer based concrete?
How can you produce desired alloys and discuss their applications in daily life.
what is escalation?how it is done?