Interested to Buy Any Domain ? << Click Here >> for more details...
what is the function of starter & choke in the tube light
set & how choke give 1000 volts while switching on.
- 14 Answers
- 86847 Views
- ADNOC Abu Dhabi National Oil Company, IBM, I also Faced
- E-Mail Answers
Answer Posted / rupashree goswami
the starter recieves an electrical signal from the
switch,then it engages and springs the flywheel turning the
engine over to prompt it to start.starter is a powerful
elctric motor that spins gasolline engine to make it
start.this is only for starter not for choak
| Is This Answer Correct ? | 3 Yes | 18 No |
Post New Answer View All Answers
why we used ZNO in Lightning arrester.
We are planning to synchronized DG's with our captive plant in the event of black start of plant, but before sync we checked voltage of DG with our plant voltage and it varies from 5 V to 450 V. So in this condition how we can sync DG with plant ?
how to compare with Relay settings for HT< panels, RMU panel, and PSS CSS transformer?? 1) Load amps, 2)Tripping time, 3) CT ratio, 4)Cable size 5) Transformer KVA rating 6) transformer full load amps
what is the generator rating for 40 amp load of 3phase motor.?? 400v voltage of generator... plz tell me with formula its urgent...plzzz... and also tell me that this 40 amp at all phases mean 40 amp on red,40 amp on yellow,40 amp on blue...... or the total sum of that 3phase is 40 amp....
In case of HV test on medium voltage cables, BS is asking for 4 U0 where as IEC is asking for 3.5 U0. Can any one advise me how this 3.5 times or 4 times U0 is derived?
What is NGR . What is the purpose of 10 sec ,60 sec rating of NGR.
what is the advantage of connecting capacitors in delta than in star?
Why lose 1 phase voltage in 33kv to 415v stepdown transformer
please send me previous year questions of jspl through which i could prepare myself for the test.
After doubling voltage from solar cells & use step down voltage transformer can we get high current output with low voltage.
What is cable tray, its type, and its support?
Please elaborate th´evenin’s theorem?
If the rated speed of a d.c. Shunt motor is1440 r.p.m, which method of speed control would you suggested to obtain a speed of 1500 r.p.m?
How to calculate the External Resistance required for 60HP slipring motor in case no any data of the Motor is available???
how can we save enegry by using VFD for Resiprocating Air compressor which is having more unloading running hours
