Interested to Buy Any Domain ? << Click Here >> for more details...
What is the meaning of key single line diagram?
- 8 Answers
- 36742 Views
- Technip, I also Faced
- E-Mail Answers
Answer Posted / thirumoorthy
it is a diagrammatic representation of a power system
components by using their symbols. from this diagram we know
the values of voltage, impedance in per unit values with the
reference of one of the equipment present in that diagram.
| Is This Answer Correct ? | 1 Yes | 6 No |
Post New Answer View All Answers
Single line diagram for dbb (double bus bar)system.
How to test lightning Arrester?
what are the advantage and dis-advantage of 3 phase 4 wire energy meter?
how to remover corona effect and hysteresis losses from contactor
What is the importance of counter based plan & how is it scheduled?
how we calculate electrical load on a building according to area?
why on delay timer used for fully automatic star delta starter?
How To Convert Apparent Into Real Power Without Knowing Reactive Power?
i have 90kw motor.so i choose connect cable .please what is parameter checked so please give to formula
what is the difference between pvc & fiber glass cables
Assuming that a dedicated neutral earthing transformer is provided for each GT generator, when the two generators are running in parallel, has consideration been given that the earth fault current from one generator stator winding be split between the two neutral earthing transformers? If so, what adverse impact will this have on the operation of the 59N and 27TN devices?
what is the minimum requirement gigaohms for the insulation test using 5kv in 300mm xlpe cable
At the starting of dc motor and syn.motor and induction motor high current flowing through the winding. Due to this the windings burnt out. To avoid this different types of starters are used. But incase of transformer what Will be used (At starting no emf is induced in the primary winding)?
temp of cast resin 1500kva tx formerwent up to 138.c but came down very fast to about 100.c within 20 mins when load was reduced from 70% to 60%
to hook up ten 50 amp rv pedastels at a lenth of 600 feet from the service what size will my service need to be and the size of wire will I have to run to each pedastel in series??????
