Interested to Buy Any Domain ? << Click Here >> for more details...
why in transformers voltage given is in the multiple of 11
- 3 Answers
- 5544 Views
- I also Faced
- E-Mail Answers
Answer Posted / k.prakashchandra
The answer given by me is wrong as 110V DC is equivalent to
110 Vrms AC.But form factor= rms value/absolute average
value and is = 1.11.If you take DC voltage is as average
value itself then Vrms=1.11 DC volts which is wrong as the
formula applies to only sinusoidal AC.Considering the line
voltage drop ,the voltage could have been increased to 110 V
from 100V in USA which was the first country to utilize
electricity.
| Is This Answer Correct ? | 3 Yes | 1 No |
Post New Answer View All Answers
Can anyone please give me the parameters , formula needed to calculate the circuit breakers for building services.Thanks
ELECTRICAL ENGINEER TEST IN FEWA ANY ONE HAVE KNOWLEDGE ABOUT THIS?????????
actually i can't understand what is 3dB ? and it's really not clear to me.please any one let it me be cleared.
what is a pilot wiring and whys that called a pilot wiers
State Maximum Power Transfer theorem.
i have a 4 Mva transformer 34.5 kv / 480-277 v and i used 2 parallel 3200 amp bus duct for the secondary feeder using 3 ply of bus bar ( 3/8" x 5" ) as a common where the flexible link terminated and 6300 amps breaker for the main, the lower bus duct reaches 70 degrees and the upper bus duct reaches 55 degrees when i used thermal scanner. why the temperature is not balance when the load reaches 3600 amps.
explain all the classes with example
What is the difference between shortcircuit current, rated current of cable & MCB with example? What will be the size of cable required for 5.5 KW motor (Full load current 10 Amps approx.), Starting current with DOL is 120 Amps. Aprrox. Short circuit current with LLLG fault is 2000 Amps Approx.
i want to know that how the height of Ct ,cvt ,LA calculated on the basis of creepage distance
how can service sitting be setted for MCCB?Example for sittings IR (CURRENT RATING),IS(CURRENT STARTING)IO (current operating)?
what is kvarh? Please define it With calculation General motors ?
I am getting above 60 V as open delta voltage against single phase unit ICT at tertiary delta formed and ICT getting trippped on NDR. ICT tested and found in order. PTs provided on tertiary are tested and in order. what may be the reason?
in battery charging room we find two fuses (one in positive other in negative cables ).why it is so?one fuse is ore than sufficient?
how the speed of the gets motor regulated. does it draw the same current on the all speed level.
At full load wat is the motor p.f And at no load will is the motor p.f?
