Interested to Buy Any Domain ? << Click Here >> for more details...
In closed loop control there are several “blocks” used to
show the interactions between the process and the control
system. These blocks are referred to as the “process” and
the “controller.” Describe the relationship between these
two blocks when creating a well tuned control loop.
- 1 Answers
- 4139 Views
- I also Faced
- E-Mail Answers
Answer Posted / tukaram
Controller: compare o/p with refferance i/p, manipulate & modify the actuating signal.
process:process the system in error free manner.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
what are the documents(Construction point of view for a process plant) submitted by contactor initially entering in to new site for client?
Can anyone send most commonly asked interview question in Oil & Gas industry
Explain plc level and its type?
How an rtd work, and what volts/current goes to a rtd to measure the resistance?
how many pulses are required by a ac induction servo motor of 4 poles with 50 Hz frequency to rotate by 1 degree?
why we use cascade control and feed forward control in 3 element drum level control measurement of steam drum .what is cascade and feed forward control system ?give example .
How does temperature bath work? How does coil gets heated only by applying some current?
Meaning of the following a. IOP- Manimum; b. IOP- Maximu,;
In which principles tx ,pressure gauge,Temp gauge,control valve works?
what does the ratio 800-400-300-200/1-1-1-1-1 in the specification of current transformer indicates?
How to calculate mmwc values into tonnes?
Programmable Logic control.
what is the importance of CV in the control valves? how it is calculated?
What care will you take in the installation of control valves,SCADA,DCS and FOC in Oil and Gas Project?
Which Signal hart communicator work? If there any signal change when hart connect while transmitter in line ?
