Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / k.prakashchandra
Manganin is correct and the composition is 86% Cu ,12%Mn and
2% Ni
| Is This Answer Correct ? | 1 Yes | 1 No |
Post New Answer View All Answers
what is the difference between changer, converter and transformer?
what is the standard values(Megger test) of resistances between L&N,L&E and N&E for a system on IEE regulations?
How can I calculate ISF of current transformer?
If I want to lift the water at a height 50m from ground level through two inch(diameter) metal pipe then what is the capacity of motor pump is required? is it possible in single phase supply or not?
Please explain me about Relay curves and their sources to read ?
How RTCC panel is working and give single line diagram for RTCC with transformer?
ii) A shunt motor supplied at 230V, runs at 900 rpm when the current is 30A. The resistance of the armature is 0.4 ohms. Calculate the resistance required in series with the armature to reduce the speed to 600 rpm, assuming that the armature current is then 20A. [12]
Is it possible to measure correct value of earth resistance & cable insulation ristance with out disconncting earth lead & both sides of cable ends? If not, any other method to measure ER & CIR with out disconneting from the system.
what is the purpose of shading ring or shading coil in electrical equipments.
In case of salient pole alternator when number of poles are 4 or more than 4 it helps the flux wave to be sinusoid as air gap length is increased from center to tip , but if the number of poles are 2 how does the flux wave is sinusoidal?
why does make gain margin and phase margin on same plot.?
if the motor rated speed is 950rpm. how to change the above rated speed? is it possible?
What is the drawback of class b amplifier? How is this minimized?
List of equipments required foe industrial repair lab.
why actual valve timing diagram is different than ideal valve timing digram of a 4 stroke engine?
