Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / karthik_elec
form factor means the rms value between the peak value of the frequency and avg value of the frequency, in DC system no frequency, so we can consider 1
| Is This Answer Correct ? | 7 Yes | 2 No |
Post New Answer View All Answers
why a tester wont shock while testing the power in house
Why are the laminations insulated from each other?
in control scheme dc logic wiring commonly using negative loop,what is the reason?if we use positive looping what will happen?
What is the height of DA, DAL, DB, DC & DDE tower?
Explain the different methods used in the choice of rotor slots for reduction of harmonic torques in an induction motor.
what is mathed of check the D.C MOTOR 181 KW (ARMATURE AND FIELD) WHAT IS THE MATHED OF CHECK THE THYRISTOR MODULE (HIGH CURRENT)
thyristor controlled APFC panel design parameter?
2 v/500amp/hr to 1.80vpc at 20 degree celsious 2v/5ooamp/hr to 1.75 vpc at 77degree farren .this is the capacity of a battery .what is the meaning of this . can i get a detailed explenation
I am using submission of two ct in one and half scheme for 67/67N protection. Both CTs star point is grounded separately near ct box.Will two point ground give wrong tripping to 67/67N during fault or no matter.
There are a trformer and an induction machine. Those two have the same supply. For which device the load current will be maximum? And why?
H.t motor 6600 volt to same motor lt supply 440volt supply applyed to h.t motor to effect....
11 kV line deraction check by an Engineer.
Explain how you can give the overload setting to any Motor Protection Relay for a HT motors with formula and example?
what is the difference between rectifier and converter and commudator?
Explain advantages of storage batteries
