in a plug point why the hole size at the top is large?
Answer Posted / shahid
If there is any fault like ground. and we connect the plug
into socket , first will connect top point. and fault
current flow through top point.Not follow any other route.
Also we will save from sock.
This is only for safe use.
| Is This Answer Correct ? | 8 Yes | 4 No |
Post New Answer View All Answers
What happened ,If 3 phase clearance not maintained in 33KV Line,11KV LIne etc?
How will you define capacitance?
Tell me about ur past electrical maintanence job
why there using acb enclosure in big buildings
1. A bomber drops a bomb from an aircraft flying at 2000 km/hr. at an altitude of 7km. The speed at which the bomb will strike the earth would be
Sate maximum power transfer theorem?
What is the formula to calculate distribution transformer De-rating on iron losses basis
What is the type of earth fault protection used in battery? explain.
How many types of protection relays are there based on the characteristic?
HELLO EVERYONE, I RECENTLY HAVE FOUND ONE PROBLEM, I WAS TAKING NO LOAD TRIAL OF AN HT MOTOR 920 MOTOR , 1440 RPM , 6.6 KV, WITH AUTO TRANSFORMER. AT 450 V, LOAD WAS 40 AMP AND SPEED WAS 250 RPM. BUT AS WE INCREASE VOLTAGE FROM 450 TO 480V, LOAD BECOME 41 AND SPEED REDUCED TO SOME RPM . SO WHICH PHENOMENON ACTED HERE FOR REDUCING SPEED.?? AND IS IT HAPPENING ALWAYS OR IT IS RARE? I ALSO HAVE FACED SUCH PROBLEM WITH FEW LT MOTOR ALSO.
Which type of transformer is used for lighting loads?
PLEASE SEND ME NTPC RELATED INFORMATION LIKE WHICH TOPICS HAV MORE SCOPE,BOOKS TO READ,CUT OFF...PLEASE.mail at thiru.1203@gmail.com
What is the function of the circuit breaker failure relay?
Is any AC drive(VFD) had a feature of DC injection braking? if available please mention the detail. i.e drive can supply braking torque when the motor in idle state.
Is it good to short Neutral and Ground in the PLC or DCS main Power supply. Pls give YES or NO with reasons...? Simarpreet