Interested to Buy Any Domain ? << Click Here >> for more details...
Why AC loads wont used in DC input supply?
and
Why DC loads wont used in AC input supply?
- 3 Answers
- 7464 Views
- Bhel, I also Faced
- E-Mail Answers
Answer Posted / rajesh kumar reddy
if we give ac supply to dc loads the heat will be developed
due tom the presence of frequency in ac supply.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
Under wat condition statcom operates as an inductor for the transmission line?
In 11/0.414 KV Parralel supply network with Bus tie closed what will be the fault level is it doubled or halved??
what is the acceptable limit value for Desolve Gas Analysis/
Give some example of fault limiting devices?
Is there possible to Test Transformer for Overfluxing Capability. Or is there any firm who does Overfluxing Test on Transformer?
Dear All, I am new in construction company , my boss ask a question at time of interview , If we have 60MW generation and Single Power Transformer step-up we have. if CMR 50/60MVA , ONAN, ONAF respectively , is it sufficient or not ? for that much power to transfer,
what is the difference between directional & non directional earth fault with example please explain.
1.what is meaning of curve into a mcb. 2.what is basic reason changing of curve
It is desired to flood light the front of a building 42 meters wide and 16 meters hig.Projectors of 30 degree beam spread and 1000 watt lamps giving 20 lumen/watt are availabl.If the desired level of illumination is 75 lumen/m and show a suitable scheme.Assume the cofficient of utilization, deprecitation factor and waste light factor are 0.4, 13 and 1.2 respectively.
A 230V dc shunt wound motor has an armature resistance of 0,15Ω.When operating on no load at 650 rev/min the armature current is 6A . The motor takes a full load current of 85A. Calculate the full load speed if the field flux is (i) maintained constant (ii)reduced by 0,03
what are the 4 rules to start the motor?
what is the need to express current and voltage in rms value? rms value is also called as effective value,what is effective value?
when elecromagnatic waves are propogated in a wave guide?
how to find the voltage's of a transmission line plzz help with pictures i am not able to understand
what is the question paper model for section engineer in RRB
