Interested to Buy Any Domain ? << Click Here >> for more details...
1.Give example of analog and digital signal
2. What is yhe advantage of 8086 than 8085
- 5 Answers
- 12403 Views
- Bhel, College School Exams Tests, Profitec, I also Faced
- E-Mail Answers
Answer Posted / mohan manohar
continuously variation between 4-20ma, which is analog signal and On or Off states which is digital signals,
| Is This Answer Correct ? | 5 Yes | 0 No |
Post New Answer View All Answers
how to calibrate 0- 150 psi presure gauge by dead weght tester
how radio frequency level probes works with its controller ? what is its principle ? pls give me brief explanation?
sir ,iam in dem urgent need of HPCL Paper of Instrumentation Branch plz send me at your earliest convenience at ujjwal_sharma1983@yahoo.com
Can Any body tell me about the Contact or Email id of any good Consultancy which help me to find a job in Instrumentation Field in India .I have Six years of Work Experience in the Same field.Please revert me back on shammi_gwalior@yahoo.com ?
A PLC is programmed to drive three motors A, B and C as follows : After running motor A for an hour, motor B should get ON and motor A should get OFF. And after running motor B for an hour, motor C should get ON and motor B should get OFF. And after running motor C for an hour, motor A should get ON and motor C should get OFF. (That is, a cyclic repetition with time period one hour) Now, the second condition is: If any motor gone faulty and is tripped, the consecutive motor should get ON and the faulty (tripped) motor should be eliminated from cyclic repetition. The remaining two motors should bear the cyclic repetition of one hour each. (For healthy motor take logic as high and for tripped motor take logic as low) Now, the third condition is: When motor A load(Amps) exceeds 60% of its rated load, motor B should get ON in parallel to motor A. And when both motors A & B are running in parallel, and if their load exceeds 60% of their rated load, motor C should also start in parallel to A & B. [Here the cyclic repetition is eliminated, until their loads become normal(40%)] [Take logic high(1) for load at 60% and logic low(0) for load at 40%] Now draw a flow chart or a ladder diagram to fulfill the above condition.
Differentiate between ultrasonic flowmeter and radar type flow meter
key exchanges in wpa,wpa2,tls
How to Calibrate Radar Level Transmitter in Field
i need some objective type questions in instrumentation
in which principle pressure tx,level tx ,flow tx,temp tx ,control valve works?
I have got a call of IOCL interview for projects having 2yrs experience. What sort of questions should I expect in the interview?
I am teja. I am studying Msc(tech) Electronics and Instrumentation (3years course) in Andhra university. But my course is not recognised by UGC and AICTE. Please tell me the job opportunities after this course. And i fineshed PLC course in IGIAT ,Vizag.Also complted my short term coure in SCADA, Seimans WinCC in ATI,Hyd.After Msc can i join Mtech for good job? or phd. How i can get good job in INdustrial Automation Side. Please give replay.Because this is my life matter.
how the arrangement of equipments done in control room
How will you test a transistor with a multimeter?
What is the reason PT speed not incresed in gas turbine?
