what is Potential free contact? where it is used?
Answer Posted / mithilesh kumar
in Potential free contact cable not present voltage.
but it's also depends upon resistance.
in this cable are in line then this 1-2 ohm resistance is
permissible.
any comment u welcome.
good luck
Is This Answer Correct ? | 2 Yes | 11 No |
Post New Answer View All Answers
what will the sending unit in the fuel gauge utilizes?
how to control pid
how to check earthing,what is minum ohms for proper earthing
How to calibrate level transmitter with use of HART?
Define the terms Accuracy, precission, Spam, process tolerance while doing calibration of an instrument? Explaini with an example?
I am having a Phoenix digital to modbus converter. The o/p of the same is connected to flow computer FB407. But the digital signals are updated only after one minute in the flow computer. what may be the cause of delay in communication? Flow computer is having a scanning period of less than 1 sec.
what is wave length were using ?
How we connect a instrument with ground, Give brief explanation with help of diagram?
How to find out the current of two motors having same power consumption but different RPM?
can you send remote seal interface level transmitter calculation steps for oil water saperator.
what is intrinscily safe system and where we use?
What is offset in a control system.
How to Calibrate Coriolis Flow transmitter in field
dear sir we have insatlled positioner model no.sipart PS2 make Siemens at our control valves . now problem is if we want to increase the response of valve opening speedy /fast. what parameters do we change for positioner ? any idea. please guide us.
How d.p. Transmitter can be applied to close tank?