Interested to Buy Any Domain ? << Click Here >> for more details...
pls give me brif explaination about the distance relay.
- 4 Answers
- 7095 Views
- I also Faced
- E-Mail Answers
Answer Posted / eniyavan
Distance Relay is also Called as Impedance Relay.
If Any Fault is Occur in Transmission Line(like phase to
Earth Fault & Phase to Phase Fault)This Relay Acts to trip
the Circit Breaker.It's Opearting for line Impedance Value
(Line Impedance=Zxkm).
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
How to identify the start and end of 3phase 12 lead motor if U1, U2, etc numberings are lost or erased.
what is the use of the puls transformer in UPS & how it works???????????
Can any answer me ,What will be the range of C.T coil for L&T energy meter EM301 used for 180 kva DG set
how we control automatic generator i'e with to supply (main supply and local generator) when the main supply was break to supply the local supply automatically to begin supplying power.I now this control circuit is the combination of contactor time delay contactor switch and overload relay .but my question is how we combine those component thank you
A 3 phase transformer's (Y-Y) Y and B phase is (Y and B connection not broken) broken from neutral and R and Nutral connection is ok, what will be the relay tripping and why
In Electrical 'Single Line Diagram' cable nomenclature shows "2 X 1C X 630sq.mm to be provided for one incomer. The question is how many cable to be proved for one Incomer.
In a Impedance Based Distance Relay (Quad Characteristics) - Could there be two different Line Angle(RCA) for Ph-Ph & Ph-Gnd? If So Kindly Let me Know.. Where, What are the advantages of the same?
why servomotor motor? where i apply for best output?
hi i will D.E.E.E.is completed pls send rrb diploma old qustion papaer sent in my e mail. i.d.
exolain the star delta connection
What is meant by full pitched winding?
HELLO SIR, IAM PREPARING HPCL EXAMS. SO PLS SEND MATERIAL OF HPCL ELECTRICAL ENG..TO VIJAY_8888@YMAIL.COM
In siemens S7-300 PLC, what is function and function block ? What is the difference between them ? When to use function and when to use function block ?
What is meant by bus bar protection?
How to synchronization will be done between two DGs ?
