What is the maximum load an electric engine can pull??
Answer Posted / deepak mishra
i think your question is not a complete one, as the load is
decided by the motor rating and and no. of moter connected
and there arrangement.
Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
what happen if drive input fail momentry at 48.5 HZ frequency?
DG Earth Value?
How good are you in resolving the commercial issues to Employer's advantage?
How to check the Bushings of the transformer?
what is proper capacitor placement? How to evaluate capacitor size?
We are planning to synchronized DG's with our captive plant in the event of black start of plant, but before sync we checked voltage of DG with our plant voltage and it varies from 5 V to 450 V. So in this condition how we can sync DG with plant ?
What is Primary And Secondary Injection Test of Relay and Other Electrical Devices. How IT is carried out.
A cotter joint is generally used to transmit
why is using sensor?what is differece between photoelectric and proxmitty?
I WANT YHE TECHNICAL AND ELECTRICAL SPECIFICATIONS OF 2x4MW 11KV 2x10MW 11KV 2x25MW 11KV 2x100MW 11KV HYDEL POWER PLANT i.e PROTECTION SYSTEM,MONITORING,CONTROL SYSTEM,GENERATION,SYNCHRONISATION,METERING PLEASE SEND THE DETAILS TO MY MAIL ID SPRAVEEN_222@YAHOO.CO.IN
following are the questions asked in interviews: 1) Considering the short circuit fault, which switchgear is preferable, SFU OR MCCB? Which operates faster? whicg one is popular in Indian Market and why? 2)Define SCPD. What is type2 coodination? 3)Why the contactor rating is higher for the fuseless selection than for fuse selection? whether the ratinf of SFU or MCCB remains the same in both the cases? 4)If the HP rating is known then can you calculate the ratings of L.V Switchgear(SFU/MCCB, contactor, OLR) without using the selection chart?
Difference between megger test equipment and contact resistance meter test instruments?
explain different types of d.c motors?
sir pls send the je exam - 2008 and other model question papers..
Why are lt windings placed near the core?