Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / thavam
DC motor starting current=starting voltage
for Ex:220 volt= 220 amps
because current limiting used for starters
| Is This Answer Correct ? | 6 Yes | 8 No |
Post New Answer View All Answers
why constant voltage transformer should be start without load? and if started then what will happen?
How to calculate the sag on transmission Lines.
I am experienced with house and industrial wiring but I don't have any licence how can I apply an licence and which type of licence i can get i didn't complete deee just only experience
in an electronic tri vector meter when the current and voltage sequence changes ? what is the effect of phase sequence on recording of meter
how can i find ct ratio of meter by seeing name plate of meter and how it should be used in MF calculation if it shows only-/1???
How much minimum insulation required between 11kv/3.3kv transformer windings?
Capacitor is load free component but why ampere meter shows current when capacitor bank breaker close?
In a power conditoining unit (inverter) of a solar plant when we measure the d.c. current fed by different strings of solar plates to inverter, the current in the negative wire is less almost by 1 ampere to the current in its positive wire say current in positive wire 5 A , then current in negative wire of the same string is 4 A. Since the current entering should be equal to current leaving then why the current is noticably less in negative wire.
Why neutral cable carry current.
How can eliminate noise problem inside temperature controller temp. variation due to contactor chattering problem.
How we can come to know the substation range,without go through any name plate ?
When is lag lead compensator is required?
what is power factor ? how we can calculate the low power factor and amount of capacitor for improve that low factor ?
what is the difference between circular wdg & ractangular wdg?
What is the maximum percentage voltage drop (vd%)for a motor control center
