What is an analog input-output
Answer Posted / saravanan m
analog input and output signal is nothing but they are
formed as a physical quantity,they should be measured and
indicating using any analog devices. example ac current
represent as sine wave form
analog and digital signals can possible to convert from one
form to another using DAC or ADC
but the digital input and output signals having two level
if they high means 1 or low means 0 example : same sine
wave represent as 0s and is at binary representation
Is This Answer Correct ? | 5 Yes | 6 No |
Post New Answer View All Answers
hey any one got the papers of SAIL and HPCL plz do help me by posting them to my mail ID's naren07_87@yaho.co.in, surenarendra@gmail.com
how to calibrate mass flow meter (Coriolis)? Example calibration range: 0 to 2500 kg/hr line size 3" fluid: Etheline glycol (MEG)
what is moisture probe? What are there types? What is there working principle and how they works? guys this is one of technical question I had ask in interview. If you know its answer please let me know. The interviewers were more interested in microwave moisture probe, so if you find its any link please just forward me on my mail id.avinash1200@gmail.com Thanks in advance.
Explain PID, ON/OFF, Controls
What is the difference between working pressure and calibration pressure of a control valve
1.what is controller proportional gain 2.what is the controller intergral action time. 3.A proportional plus derivative controller that has a proportional band of 20% and a derivative action time of 0.1 minutes. Construct the shape of the output waveform for the triangular input if the input rises and falls at the rate of 4 units per minute.
I have a Control VAlve having size of 2 ".Only the known parameter is Pressure drop . Its 2 Kg. Then How to calculate control valve sizing means Cv.
pls suggest suitable MOC of diaphragm for pressure measurement of UREA grade solution service fluid.
Can please tell mi about SIOS, PRM, SERVER, and what is the diference between PIN LAN, PCS LAN,APC Server, and please send the Doc if possible for referance,mail id patil_amit17@yahoo.com
What are the charcterstics of a P&ID controller block for Governor speed raise or lower for a load sharing functionality between 4 Gas turbines in droop mode.
What denotes the 5/8mm in the 3300XL 5/8mm proximitor probe?
key phaser where is use and work
How u will setup SPI(2007) on Citrix Server (Thin Client Mode)? Plz Justify?
How d.p. Transmitter can be applied to open tank?
how can i calibrate the temperatuture gauge used by temperature bath(dry block) i mean step by step procedure?