Interested to Buy Any Domain ? << Click Here >> for more details...
what is ultimate tensile strength? for any material give
relation ship between various stretgth like tesile, shear,
% dformation?
- 7 Answers
- 22347 Views
- I also Faced
- E-Mail Answers
Answer Posted / arunfreddy
the ultimate load is the load at which the structure gonna fail.if the structure is optimally designed then it has to fail at ultimate load.
design limit load-the structure should not fail at design limit load throughout the service life.
ultimate load-the structure should fail if it has to experience the ultimate load.
| Is This Answer Correct ? | 2 Yes | 2 No |
Post New Answer View All Answers
Can you give me detail of Diesel Quality parameter in use of DG sets.
i have completed b.tech from mechanical engg so plz send me some question paper for entrance exam
sir i have to face an interview for marine trainee engineer on 15 sept tell me some related questions which r genrally asked...
How much pressure on air reservoir?
Enthalpy and entropy are functions of one single parameter. Which is that ?
22216 CC bearing
Which reactor uses primary coolant as fluoride salts of lithium, beryllium, thorium and uranium ?
"In refrigeration, why during operations is running low pressure at the suction side?"
Explain the advantages of powder metallurgy?
what are the uses of eutectic alloys?
What parameters to be reported when we send lubricating oil for shore analysis?
What was the hardest part of obtaining your engineering degree?
List out the points of diesel generator B check?
what is the pattern of written test for the post of trainee mechanical engg.
My vendor filled liquid oxygen in our 11000 liter capacity tank. He filled from 1400 MMWC up to 3200 MMWC. I followed the provided conversion table and found that we had been supplied 1800 MMWC liquid which is going to yield 2815 cubic meter. On the other hand, the vendor claims that he supplied as follows:- 5236 cub mtr(3200 MMWC)-2124 cub mtr(1400MMWC) = 3112 cub mtr. I fear that he wants to charge 297 cubic meters extra. He claims that my method was wrong and his was right. He says that this disparity is because of the conical shape of the base of the flask. I will be thankful if somebody can explain me the truth.
