Interested to Buy Any Domain ? << Click Here >> for more details...
why do star-delta connection ?
why do not connect any circuit direct connection ?
- 1 Answers
- 4417 Views
- IBM, Sri Biotech, I also Faced
- E-Mail Answers
Answer Posted / pillay
when the motor is started on star only about 60% of the
full voltage is applied across the motor winding. So the
current used is reduced but enough to start the motor with
the load.Once the motor picks up speed the current used is
reduced further, than the connections is changed through the
starer contactors to delta where the full voltage is applied
across the windings to enable the motor to function fully at
its rated voltage.
so the motor is started star and than run delta to reduce
the starting current.
| Is This Answer Correct ? | 7 Yes | 0 No |
Post New Answer View All Answers
why we get 2 differnet values for power factor in 2 watt meter method in 3 phase
We have two APFC panels in same station. I need how to connect CT in two APFC panels.can we take one CT in series connection or two separate CTs.
wat system call?
Do u know any one? how to find out in motor rated amps? formula?
How to select the proper VSD to operate high inertial load
what is the basic need of domestic loads 1- voltage 2- current
what is conductor constant of raccun conductor
1- What is the Polarization Index number be good for 15KV 3c#500MCM electrical cable? 2- Can I use the IEEE Std 43-2000 to perfom the PI test? Thanks
how to test the electrical panel.ht lt mcc pcc.
what is the difference between capacitive and resistive voltage divider?
state the working of discharge lamp?
what kelvin's law ?
what is mean by Digital Logic Meter (DLM)
how to select overload-relay for perticular motor 1.for D.O.L. starter 2. for Star-delta starter ????
how to calculate the power factor when instantaneous voltage and current has harmonics in it ?
