how to calculate the multiplying factor for energy meter
with CT ratio given
- 23 Answers
- 253025 Views
- Bhel, Dalmia Group, DIFC, Fedco, Hindustan Unilever Limited, Lupin, MahaDiscom, MAL Pakistan, Myunghwa Automotive, Panchshil Infrastructure, Regala, RVPN, VIPL, I also Faced
- E-Mail Answers
Answer Posted / mazhar
Suppose CT ratio 100/5 then MF will be 20
then If you want to know the consumption so you
(Total Reading *MF)= Total Consuption
| Is This Answer Correct ? | 229 Yes | 84 No |
Post New Answer View All Answers
What are the raitings of Mcb,mccb and Acb in detail ??
State the points to be considered for selecting a particular type wiring.
1.dg on load alarm/stop alarm... 2.dg on load. piu alarm alarm kaise chek krte hai
why chock were used in old tubelights but are not newest tubelights?
why we have to particulary use ACB for below ratings,even available of MCB,MCCB with that range ?
by what factor the starting current is used when comparing star and delta connection for motor starting?
where was current transformer protection units used and why??
How to design inductive load for 3 phase 440v and maximum 5 amps for star or delta? Can we use a 15kW, 1450rpm motor for 15kW, 960rpm apllication?If yes.how......n.if thesame motor used what`s it`s sideeefect.
why magnetising curve not start with zero voltage?
What type of core material is used for metering C.T and protection C.T???
If only R Phase is connected in 2 pole elcb, n is not connected than it will work or not in ground fault.
What is dc current source?
what is the difference between "Rotary bypass isolation switch and Normal bypass switch" pls share indepth techs?
Why ground terminal is used in pot meter 10k ohms
State Maximum Power Transfer theorem.
