is 3-phase induction motor need a starter ? why do it so
- 5 Answers
- 6479 Views
- Coca Cola, I also Faced
- E-Mail Answers
Answer Posted / pradeep kumar patel
yes, bcz 1-starting current is (5-6 times)greater than
supply current .2-starting toque is (1.1 times) greater
than normal torque.
| Is This Answer Correct ? | 10 Yes | 1 No |
Post New Answer View All Answers
block diagram of 2 ups system connected in parallel mode?
What is proportional controller?
What are the advantages and disadvantages of closed-loop control system?
Why the output of OP-AMP is always less than Vcc?
why HT armoured cable does not glanding
electrical knowelge
HELLO EVERYONE, I RECENTLY HAVE FOUND ONE PROBLEM, I WAS TAKING NO LOAD TRIAL OF AN HT MOTOR 920 MOTOR , 1440 RPM , 6.6 KV, WITH AUTO TRANSFORMER. AT 450 V, LOAD WAS 40 AMP AND SPEED WAS 250 RPM. BUT AS WE INCREASE VOLTAGE FROM 450 TO 480V, LOAD BECOME 41 AND SPEED REDUCED TO SOME RPM . SO WHICH PHENOMENON ACTED HERE FOR REDUCING SPEED.?? AND IS IT HAPPENING ALWAYS OR IT IS RARE? I ALSO HAVE FACED SUCH PROBLEM WITH FEW LT MOTOR ALSO.
We have 90mX100m hangar with 16 no.of supporting pillar. It is required to provide power supply on all pillars. what is suggested earthing scheme for hangars.
i want to apper for apgenco or aptransco or related can any one sugest me where can i get previous papers of thouse exams
Does all the output contacts (N/O as well as N/C) of a Numerical relay operate when relay receives a binary input/inputs or contacts are designated to specific logic input/inputs and only these contacts operate?
which IS or IEC is used for earthing,breakdown voltage of transformer oil, hv/pd testing and all type of electrical testing
Draw a SLD of HT distribution EB grid up to users Transformer?
What is a parabolic signal?
what is the difference between torque induced and torque load?compare them with respect to dc motor?
What is q factor?
