Interested to Buy Any Domain ? << Click Here >> for more details...
what is the difference between NP2 Class and NP3 Class RCC
Hume pipes
- 8 Answers
- 34969 Views
- GWRDC, IVRCL, IVRL, I also Faced
- E-Mail Answers
Answer Posted / ramakrishna
NP2 class pipe having bellmouth joint and NP3 classpipe
having coller joint for jointing two pipes
| Is This Answer Correct ? | 5 Yes | 10 No |
Post New Answer View All Answers
what might be the problem faced in the near future if the M-sand is used in the place of river sand during wall plastering? (As per IS)
How did the romans get water up hills using aqua ducts?
how i convert mm into standard wire guage (SWG)no.
what is difference between GTS bench mark and temporary bench mark
With reference to construction of state highways, please let me know the total Bill Of Quantities as per the following details:- 1) Subgrade - 500 mm 2) Granular Sub-Base (GSB) - 200 mm 3) Wet Mix Macadam I (WMM I) - 150 mm 4) Wet Mix Macadam II (WMM II) - 100 mm 5) Dense Bituminous Macadam (DBM) - 60 mm 6) Bituminous Crust (BC) - 40 mm Road Length is 44 Kms. Road Width is 7 mtrs. Please provide the BOQ of each layer as per Compacted Factor & Loose Factor both. Also, if possible please provide me the approximate details of total material required (all categories viz. soil, gravel, stone aggregrate, sand, bitumen etc.) as per general mix design prevailing in India. Thanks & Regards -- Rokr
HOW MUCH STEEL REQUIRED FOR SLAB OF AREA 23'3"*18.3"? FOR SLAB HOW MUCH DIAMETER BAR WILL USE?
Hollow block masonry in cement mortar 1:4, 40×20×20cms in superstructure take 10sqm.I want calculation of brick sand
Define What is a projection line?
(Project Management Topic) What are the important criteria in the successful realization of the project?
please send me bhel questions on rupesh.017@rediffmail.com
Why steel rods are produced only in even dimensions?
types of piles detail,
How to calculate cement, water, fly ash amount for 1 cum if the w/c ratio is 0.4 and fly ash to cement ratio is 1:9
I want to know how much the lapping length for the pilecap reinforcement.. we r using single pile cap which is 24mby54m and 2.5m depth.. total 91piles are supporting the pile cap.. how to do a steel reinforcement??
What is type failure of road surface? how to repair the failure of road surface?
