Interested to Buy Any Domain ? << Click Here >> for more details...
What happen if we give resistance to the
armatuure of a dc motor?a
- 1 Answers
- 3497 Views
- I also Faced
- E-Mail Answers
Answer Posted / sharath
speed of the DC motor decreases
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
Can i replace Earth leakage relay to the faulty Earth Faulty Relay
Practical condition in 400KV Sub station:- Breaker(open) , isolator(open), Earthing (close) at both end e.g A & B. Now Open A Stn Earthing than Open B stn Earthing (Which have a 50MVA reactor) , AND suddenly show R,Y,B phase 704KV,573KV,118KV respectively. Que is without closing of breaker how it is possible.???? My Whats app No:07621840498 for Further Discussion. Pls experts suggest.
what will happen reduce the transformer voltage from 415v to 406v, is it save the energy,? are this methodis good to reduce the energy.?
what is the effect of un-synchronized power.
Why synchronous motor is used in power factor improvement,dc series in lift
Difference between rating factor of cable and derating factor of cable?
A 7 storey building has a floor area of 35,000sq.ft on each storey. On the ground floor 11KV electrical sub-station is to be erected. A load of 3kw for every 400sq.ft (p.f is 0.8) is proposed for each floor. fire pump 7.5hp, water pump 5hp, lift 2 nos, each 10hp and 20shop load of each shop is 5kw. calculate a. load each floor b. total load of building c. L.T feeders for aech floor and from transformer to main. d. distribution diagram e. capacity of sub-station/capacitor bank f. line diagram
what is the safty of poly phase tranformer?
We have drive feeding an output contactor for a 5000 hp motor @ 5kV application. The motor FLA is 629amps x 1.25% service factor = 786.25 amps The cable that we current have in place between the drive and the output contactor is 350kcmil- MV-105 (parallel cables). Per the NEC table 310.60 (C) (69). This show the cable ampacity is at 615 amps per cable for a rating of 1230 amps. We have derated the cable for the cable tray and the multiple cables application and our calculations show that after the correction factor factor we are at 922amps. 1230 amps x .75% correction factor factor = 922.5 amps. The customer is driving us to then use another safety factor of .25% off of the already derated cable. Can you please provide a longhand calculation for your solution on this application?
what is the relative size of single and three phase?
What Is Connection APFC Panel In Compony.
how we arrange the hv side with delta connection in case 33/11kv of transformer.
how many joint can done in HT line and what is life of the joint
xpression 'document.FrmQF.myemail' [
What are the no-load losses for the 11000/415V transformer with the following rated capacity? 1.1500 kVA 2. 2000 kVA 3. 2500 kVA 4. 3000 kVA
