Interested to Buy Any Domain ? << Click Here >> for more details...
In a overhead system why the voltage between line &ground is
taken for basic comparison ?and in case of underground
cables the comparison take only by the voltage between cables?
- 1 Answers
- 4024 Views
- L&T, I also Faced
- E-Mail Answers
Answer Posted / krushna ch sahoo
generaly the comparision made for
capacitive losses.in over head line
ground to line capacitance is taken
account but in under ground line to
line capacitance is taken for
calculation
| Is This Answer Correct ? | 10 Yes | 1 No |
Post New Answer View All Answers
HOW DO I CALCULATE THE SETTINGS FOR THE DIFFERENTIAL PROTECTION OF A 12kV/6.6kV, 6MVA,DYN11 XMER WITH PRIMARY SIDE CTR 400/1 AND SEC SIDE CTR 600/1?
Please brief what is sinewave
which types of relay used in acb and vcb?
why is the power generator connected as star earthed or star earthed through reactance and what its features ?
send me any model test paper of clerical post of state bank of india.......
WITCH CARDS IN USE IN FIRE CONTROL PANEL.
WILL SCHNEIDER MAKE ACB(MASTERPACT)TRIP ON REVERSE POWER?
what is data block in plc ? How the values of data block are written and read by hmi ? what is the difference between function and function block ?
Draw a 230kv two-bus bar system showing the following. 1.Two generators (150MW) each connected through one 15.75/230KV transformers 2. 1 outgoing lines 3. Two 230/130 KV transformers 4. BUS PT's 5. CT
why 3 phase is converted into 2 phase using electronics circuit why not 2 phases are diresctly putted from the 3 phase transformer??
Sir, My doubt on cable sizing calculation, Load:74 KW calculated cable 1 run 50mm2. Now client asking us to reduce cable size by increasing runs. Sir, My question now when my mind strikes with 2 options 1) Divide load 74/2 = 36 and calculate cable for 36+36 making it 2 runs or 2) Simply i can divide 50mm2 /2 ie. 2 runs of 25mm2 Please suggest me sir
which is better to use svc or synchronous condenser why ?
if 6 earth pit value is 1.5 ohm then what should be the number of earth pit to make the value .8 ohm
What will be the size of copper cable (each for 3 phase and 1 neutral) from Service connection Kit-Kat to Panel Board (i.e. to main switch) for a 6 pole 3-phase AC induction motor of 200 H.P. capacity? Amp-255 A, Frequency:- 1450 rpm.
What happen when change order of CT in GIS feeder?
