Interested to Buy Any Domain ? << Click Here >> for more details...
Under Ground Power cable earthing is required at both end or
single end? and reason for the same
- 3 Answers
- 5987 Views
- I also Faced
- E-Mail Answers
Answer Posted / vishal
Should be earthed at one end only for the reason above
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
Write the programming software name for LG, SIEMENS,Messung,AB
How line capacitance & line inductance varies with increase in height tower.
Starting times for soft starter & power factor is thier any standard or datas available in manufactures list. Kindly suggest.
why we permissive overreach in distance protection.where it is applicable to use in long r short lines
How would your past experience translate into success in this job?
1)how to reduce the value of tan delta of trasformer and CB,bushing,CT&PT,CVT ? 2)how to reduce the resistance of CB contact and its operating time? 3)plz.....send me the project report on conditioning and monitoring of substation equipment on my email id (gusaiyogendra03@gmail.com)
What is the use for cable entry in control room?
Explain RLC circuit?
what is lrs tank water resistance.
What is difference between Over Current & Earth Fault protection?
what is mean by kneepoint voltage? when it will happen? ( my doubt is, if CT secondary is open means ct get saturation or blas? what are factors are required for calculations? plz give currect anws:
how to size H.T & L.T Panel ?
what is the meaning of 0.5ohm Resistance
If a 3 phase induction motor is in off condition in the conveyor and rotor of the motor keeps moving with the conveyor than the resistance of windings of motor varies. why is it so ??
what is data block in plc ? How the values of data block are written and read by hmi ? what is the difference between function and function block ?
