The neutral&earth voltage is 0v.But we were connected the lighting load at the time ballast was failed.why?
Answer Posted / k.prakashchandra
The earth is not used as a supply terminal.It can be used
for earthing metallic parts.It appears that you used the
earth wire in place of neutral.What kind of failure was
there in the ballast ?
Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
explain safety measures in alternator?
what is cathodic protaction?
What are the limitations of Kirchoff's laws?
how to modify DOL control panel into Delta Y connection?
1.What is the range of stator resistance of 3-phase induction motor? 2.Two electrically operated vibro motors are foxed in parallel direction in vibrating feeders. what is the direction of both vibro motors?
What is different between Difnit time and instatous over current relay
IF I KNOW THE AREA OF CROSS SECTION OFTHE WIRE , WATTAGE OF THE LOAD ,VOLTAGE SUPPLY WHAT IM GIVING TO THE LOAD AND ALSO POWER FACTOR OF LOAD ....... SO GIVE ME FOR WHAT AMOUNT OF CURRENT I SHOULD USE WHICH TYPE OF CABLE?
What is CVT and what is relation with wave trap?
What is meant by sag?
WHAT IS MEANING OF Gg & Gg IN hrc FUSE
Currently what is the highest capacity (MVA) of SPPg generator available in the market?
Why are the cores of large transformers built up of circular transactions ?
what happens when series resonance occurs?
what is the difference between fault current ant short circuit current?
I need to connect a synchronous generator to the grid using automatic synchronization and two circuit breakers (one for synchronization, one for end connection to the grid), how to determinate the required diameter of the cables?