Interested to Buy Any Domain ? << Click Here >> for more details...
why the amount of voltage generated at power generating
stations is 11 KV only....?
- 3 Answers
- 5240 Views
- I also Faced
- E-Mail Answers
Answer Posted / amit kumar singh
It is not necessary.
The output voltage at which generator generates power
depends on manufacturer.
Now a days, Generator with rating 660MW is having output at
20kV voltage. But it may also vary.
| Is This Answer Correct ? | 3 Yes | 3 No |
Post New Answer View All Answers
why power factor is important?
According to conduit size which size wiring & how many wires can we provide wires in conduit & how can we select conduit size accordingly?
Trafo ratio is 11kV/6.6kv,Vector group is YND11. What will be the effect if secondary is used for earthed system.
how does the terminal voltage of transmission lines increase when a capacitor is connected???? This happens not only in transmission lines but also in all circuits. How??? When a capacitor is connected in a transmission line, capacitor also takes energy from the same supply. But how is it able to increase the terminal voltage??? Practically What sequence of events happen during increase in voltage???
If we use 250A MCCB as a incomer in Control panel for a fault level of 50kA for one second ,assuming temperature rise from 85 Deg. to 100 Deg , Then what will be the Aluminium Bus-bar size for 250A MCCB? Explain in detail.
how can maintaince the acb contactor moveing and fixing kit
A 11KV, 1200 A breaker combination fixed in a cubicle for HT motor.Is normally for 11 KV motor fuse is using? if Yes, What range fuse is required?
What is the de rating factor of cable? What is the importance of the de rating factor in cable select
In our factory so many iron pillors are exists for supporting the shed/Hangar. If do more no of earthings at one piller instead of doing more earth pits in many locations and running earth strip around the hanger, I can save the money. Please suggest this method is acceptable as per Is specifications though the Earth resitance of the farthest piller is with in the limits as per IS specifications.
Is there any rule to select the voltage of motor based on KW rating? What is the rating above which lt motor becomes the HT motor?.
why can we use cosine wave instead of sine in ac supply as both have same rms vale and ripple factor
when generator short circuit condition, the current how dissipates. or at short circuit voltage not available then current how can flow?
Why is the frequency not changed during transformation of electrical energy in a transformer?
what are factors to be consider to design a HT & LT motor?
what is the significance of tan&delta and how it performed in power transformer
