draw a circuit diagram connecting transformer OLTC- RTCC-
VCB-Marshalling Box otherwise Explain in words
- 1 Answers
- 22126 Views
- I also Faced
- E-Mail Answers
Answer Posted / alleysyed
OLTC stands for On Load Tap Changer, which means that a user
can change the taps of transformer winding without
disconnecting the transfomrer from the supply. Taps are
changed in order to regulate the voltage. OLTC has number of
taps . They may be 10, 11, 16 , 20 or the customer specified
rating.
Marshalling box is a box in which manufacturer of
transformer bring alarm and trip contacts signalling from
the accessories associated with the transformer. For
example, Oil temperature indicator installed on the T/F
provide a signal of alarm when the temperature of oil
exceeds the specified limit of Indicator. If temperature
exceeds more, it send the trip signal to Marshalling box,
which disconnects the transformer from main supply and
vacuum Circuit Breaker is tripped. VCB is installed on the
High Voltage side of the TF in the HV Protection panel.
| Is This Answer Correct ? | 31 Yes | 5 No |
Post New Answer View All Answers
I have a relay contact rated at 220v dc which is supplied with a 24vdc from the panel,for it to trip the dampers(24vdc).What if the application of the relay changes so that it should work at its rated 220vdc then will it work at 24vdc supply given or any other consideration needs to be taken .....
What is I to C?
What is the drawback of static coefficients?
1)what is the function of a frequency inverter? 2)If a few frequency inverter are connected onto a device network,what are the two setting that will ensure the frequency inverter work properly on the network. 3)whats is the name of the input sensor for weigher? 4)How to confirm that the load cellis faulty? 5)Describe briefly the steps to validate that the weigher is working properly? 6)Describe the procedure to validate the flowmeter accuracy? 7)Describe briefly the steps to validate that the tempreture sensor/transformer is working properly. 8)what is the adjustment that need to be done when you are calibrating the temperature transmitter ? 9)what are the safety measures to be taken before disconnecting motor for rewinding. 10)whats is the synchronous speed in rpm of typical 4pole 50hz motor? 11)whats is the formula for kw, ohm's law 12)if a 3phase motor is rated 3kw,415vac,what is it's rated ampere?
I am experienced with house and industrial wiring but I don't have any licence how can I apply an licence and which type of licence i can get i didn't complete deee just only experience
When calculation of fault current and fault Kva is to be done,why always we use per unit value and why we consider the base kva?
why single phase to grd test in HV cable?why not 2 phase at a time?
What are the material used for resistor?
use of PIR in ehv breaker
our industries ht line so power fluctation(once drop of power please rectify causes
is oil viscosity affect on motor current?
how could we know the size of cable by physical view?
What happen Grid EARTH plat got cut.
What is Percentage impedence of a transformer? why it is expressed at a percentage? what is the importance of percentage impedence in case of a transformer?
in dc series motor if field wdg is shorted then
