how much steel required for 1 sq.m area?
Answer Posted / rahul
It depends upon the load on that area acting....if the load
is more than more steel will required....and if load is less
than less steel...
(if somebody has more problems for interview..please share
with me...mail me at rahuljainy245@gmail.com)
Is This Answer Correct ? | 10 Yes | 5 No |
Post New Answer View All Answers
What is the yield of 100 litres of water and 10 kg of cement in grout mix?
How to calculate the cement and fine aggregate requirement for solid block masonry works in terms of Sqm. 1. 400x200x200mm 2. 400x200x100mm 3. 600x200x100mm 4. 600x200x200mm I need the answer for 1 Sqm of solid block works.
For the calculation of bearing pressure below the footing, to know whether it is below the safe bearing pressure of the soil, the unit of RCC below ground level to be taken is 25 KN/m3 or (25-15)KN/m3, where 25 is the unit weight of RCC and 15 is the unit weight of soil and whether the weight of backfilling to be taken?
The definition of national highway
a rectangle grill of length 72 inch x 20 inch width.how to calculate bar spacing ,bar consist 8 mm thickness and spacing of bar is 2 inch.. calculate no of bar with formula
Explain what is structural frames or systems?
How many are the types of joints?
what quantities of work done in terms of sq.mts/day/ of 8hrs for each varpenter (shuttering) and Steel fitter in terms of Tonnes. For slabs, Columns etc.?
how to calculate the material from ratio of work PCC, RRM,POINTING, RCC
What is the veriplus for ellips card length formula (major axis 3.4m,minar axis 2.6m spacing 0.2m
GIVE US YOUR FULL DETAIL OF THE FOLLOWING… FULL NAME.. PERMENENT MAILING ADDRESS DIRECT CONTACT NO E MAIL ADDRES.
what is the soil bearing capacity for a 5 floor multistorey residential building and which type of soil ? what is plinth beam? in wall load calculation center to center column distance is considered or not/
hi guys what happens if you are absent for a supplymentry exam?
Who built the sears tower?
How can we make a hole in a solid rectangle using solidsworks?