Interested to Buy Any Domain ? << Click Here >> for more details...
WHAT IS THE SPECIFICATIONS CONSIDERED DURING DESIGN FOR THE
OVER CURRENT RELAY?
- 3 Answers
- 4948 Views
- I also Faced
- E-Mail Answers
Answer Posted / manoranjan mishra
While designing any type relay we have to consider first
the current setting of the breaker which is sensing to
relay operating coil.if it take more than its rated current
then it trips the relay which is connected to equipments.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
what is difference between speed mode and torque mode in motor?? explain in simple words please.
Define characteristics impedance?
What is the distance between body earthing and neutral earthing.?
why do we carry out winding resistance test?
how single phase preventer works ?
what is the difference between fault current ant short circuit current?
Why it is possible to use PWM with a STATCOM and not with a conventional TCR based SVC
Why mostly the HV side of transformer has Delta?
State superposition theorem?
What will be the fault current of any system when its generation is 10% of BASE generation( FUll Load )?Will is 10% or the same as full base calculation?
What is Phase to Phase clearance for 800V System Operating Voltage as per IEC61439
some time we open engine breaker 8.0 MW load but plant not trip. and another time engine open 4.0 MW load engine trip why? individually engine breaker open & individually emergency stop why difference?
Define the term factor of inertia.
How can we findout the maximum efficiancy of Transformer? At which load?
All tape of electrical questions Answers tape of motor transformer e.o.t crane
