Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / salman
isometric view we draw by taking 30* angle with ref plane
and we get lenght , Height & width of object so
| Is This Answer Correct ? | 5 Yes | 2 No |
Post New Answer View All Answers
hello sir iam atul joshi from mechanical branch. i want to know about the syllabus of technical ques of jindal steel
what is procedure of measuring operating length of mechanical seal .(in case of centrifugal pump)?
Steering handle (round dial) of motor vehicles (CAR,BUS,LORRY) wiil be designing with two cross supports without 180 degree straightness( it will be little bit cross). Why?
please inform about the date of exam of hpcl for fresh engineers recruitment in mechanical stream?
How are the pneumatic system and the hydraulic system similar?
What is the difference between Muff Coupling and Screwed Coupling with Cotter pin used in pump line shafts.
How will you classify sliding contact?
which type of material is F125?
Which material amoung EN8 and EN24 should be selected for the designing of the shafts of rotary kilns
What valves are fitted in a four-stroke diesel engine?
Tell us how do you discharge your duties in your duty post
What is the maximum use of magnesium ?
What for schmidt plot for is used in heat transfer problems ?
Did you have a favorite project that you had to do while in school?
Why should we hire you over the others waiting to be interviewed?
