Interested to Buy Any Domain ? << Click Here >> for more details...
how to calculate the load on transformer..????
- 2 Answers
- 6320 Views
- Bhel, I also Faced
- E-Mail Answers
Answer Posted / jaspreet singh
Dear sskmb, Load Always connected in secendary of
transformer.To know about load we should know about the
rating of transformer.T/f Load can be measure by Amp
Meter /KW meter on the swcondart of T/f
| Is This Answer Correct ? | 4 Yes | 0 No |
Post New Answer View All Answers
1. for eg, capacitor is used for many purposes(it act as filter, oscillator, bypass capacitor, memory storage etc...) 2. Please tell me some example circuits for different uses of capacitor( whenever and whereever and however we used capacitor as a filter, oscillator tuning etc..) 3. similarly for inductor and resistors(it act as what?) and when and how we want to act as like that?, and how we can used these components depends upon our requirments with example circuits and explanation? design to act as these components depends
A Generator is in running condition and Rotor earth fault alarm is coming.How to check on line(i.e in running condition) whether there is actual earth fault in rotor or not.
What is force on a conductor in a magnetic field ?
How u can give the overload setting to any motor protection relay for a HT motors with formula and Example?
Where is servomechanism used?
In CTs tan delta point should be earthed , what is the reason behind it?
WHICH SIZE A.B.CABLE IS USED FOR 11KV.
Define steady state error.
can any one provide me a connection wiring diagram for a DG set control panel along with BOM?
A 15 kw squirrel cage motor having a maximum efficiency of 90% on a continuous full load has temperature rise of 42 degrees celcius after 30 min and 52 degrees celcius after 1 hr under the above operation conditions. a) calculate its final steady state temperature rise on continuous load and the heating time constatnt. b) if the motor is operated on a short load for 9 min estimate its temperature rise. c) calculate the maximum overload that can be applied on a short, 9 min rating so that the temperature rise is the same as the final steady state temperature rise on continuous load.
What is difference between mcb and mccb.
why the earth is taken minimum in supplying? wather it the proportional factor to getting work any equipment or a power plant?
Please help me regarding my one concern. - During earth pit testing we noticed that the Clean earth pit and dirty earth pit showing continuity (Resistance value - 5ohm) . I want to know that if both earth pit have separate location and there is not internal looping between PIT then why such continuity is showing on it . Because of this issue the field side all earthing point showing short. In PLC panel we are providing two types of earthing cable which is coming from separate earth pit (Clean and Dirty earth pit) because of earth PIT showing short our PLC is not complying spec . please help regarding this issues.
what is the pre charge circuit,what will be work which function it will be use plz tell me
WE ARE PLACE A NEW 75 KW MOTOR FOR JPF.IT IS CONNECTED IN M.C.C. WHEN WE ARE STARTING M.C.C.INCOMER IS TRIPPED.THEN WE ARE CONNECTED IN P.C.C WITH A MM30 RELAY PROTECTION THEN WE ARE STARTED MOTOR WILL RUN SMOOTHLY.
