if u have three steam turbine blades, how will u find which blade is for low pressure, high pressure and medium pressure?????
- 5 Answers
- 8185 Views
- Bhel, Sail, I also Faced
- E-Mail Answers
Answer Posted / salai jeyaveeran
generally the steam turbine is shown in horizontal v-shape
position which indicate that the blades will be smaller for
high pressure side and slight big for medium pressure and
bigger for low pressure this to compensate the expanded
volume of a steam in a turbine
so
small size blade = high pressure
medium size blade = medium pressure
long size blade = high pressure
| Is This Answer Correct ? | 18 Yes | 10 No |
Post New Answer View All Answers
please send me model question papers for DVC Examination diploma mechanical
sir iam vinod kumar i have done B.TECH. in mechanical engg in 2007 i want to choose career as section engg.please give the information about coaching institute.
what is the difference between type -a and type -b iron > The chemical compostion is given here under and also guide us the effect of Ni;Cr;Mo in the iron; name and use of these two types of iron Type a Type b %C :3.15 2.65 %Mn:0.41 0.52 %Si:1.72 1.60 %S :0.090 0.082 %P: 0.215 0.204 %Ni: 0.40 Traces %Cr : 0.49 Traces %Mo : Traces Traces
Quantities like pressure, temperature, density, viscosity, etc. Are independent of mass. What are these called ?
what will be the minimum bearing clearance that after it will not profitable for machines?
difference between machining and non-machining?
Define monochromatic emissive power. [EbĪ»]
Discuss how to prepare the M/E in the standby condition
What is the cause of pressure drop in a centrifugal
Why air is not used to run the turbine?
hai this is sreenu...i also applied for the post of PO in syndicate bank..
hi friends kumar here if anybody of u have " INDRAPRASTHA GAS LIMITED" placement papers than plz send it to me i need it urgently..ok mail id is ashish_me2007@yahoo.co.in
What is torque converter?
Study the attached ACS 790 AHU and boiler GUI and refer to the video on the software usage, catalog and the step by step document (page 9) to perform the following task: List in a table form the controllers and all their connected I/O for the boiler and the AHU.
what is the stanton curve?
