Interested to Buy Any Domain ? << Click Here >> for more details...
What is the function of semicon in 33kv ht cable ?
- 4 Answers
- 18470 Views
- Denson, Finolex, I also Faced
- E-Mail Answers
Answer Posted / k.prakashchandra
It is used to influence the electric field within the
insulation layer.The semicon layer has to removed at the
termination at least 6-9 inches below the lugs ,as
otherwise there will be short circuit along this layer.As
this layer is not doped, you have to treat it as a conductor.
| Is This Answer Correct ? | 10 Yes | 4 No |
Post New Answer View All Answers
Why HT 11 KV Slipring Motors are connected in star ?
Which type of a.c motor is used in the fan (ceiling fan, exhaust fan, pedestal fan, bracket fan etc) which are find in the houses ?
In Plumbing services What are accessories we consider for a bathroom?
What is power in wattage of 8.5 TR AC
Please brief working principle & construction of permanent magnet AC Servo motor
What are :- AC Distribution Board (Single & Double Front) DC Distribution Boards Distribution Board LT Breaker Panel.
Do inductive loads have distorted current waveforms ?
What is the formula for selecting the cabels according to load? How to calculate what sq.mm cabel to be used?
UG cable sizes were specified in sqmm. But practically its not coming to mesure. What's the reason for that? And how they specify the size of the cable?
i have total 8 dg sets for synchronizing and 2 buscoupler,1 sectoin dg no 1,2,3,and 2 sectoin dg no 4,5,6,and last section dg no 7,8 ....if buscupler no 1 and 2 is off mode ..than dg no 1,2,3,will synchroniz of another dg sets?
How to Decide(calculate) Bush bar size for copper and aluminiam ?
What is the effect on Power factor and capacitor when your company load is more than 70 % of welding transformer
how we control automatic generator i'e with to supply (main supply and local generator) when the main supply was break to supply the local supply automatically to begin supplying power.I now this control circuit is the combination of contactor time delay contactor switch and overload relay .but my question is how we combine those component thank you
i will applied in 1U-1W on 440 volt primary delta side. what is the result of magtic balance test
WE know that for Inductor X=2pifL,In DC f=0,then X=0 so,V=IX=0;But In the DC excitation of rotor of AC generator,DC motor field coil which coils are inductor so why does not applying DC voltage short the rotor coil of AC generator and field coil of motor?If it would then DC source might be damaged but it is not happened. Why does the strand conductor of Electrical power transmission line make twist?
