Interested to Buy Any Domain ? << Click Here >> for more details...
by mixing oil in fule of fourstroke bike will it damage
engine, performance? if not than what happen?
- 5 Answers
- 11750 Views
- Yamaha, I also Faced
- E-Mail Answers
Answer Posted / er.zafar iqubal khan
absolutely it will hamper engine performances bcz of etra
oil spark plug gets wet and stops working properly thus we
will have starting problem
| Is This Answer Correct ? | 1 Yes | 3 No |
Post New Answer View All Answers
Mean effective radius of contact surfaces of a clutch plate is decided by a) Coefficient of friction b) Axial pressure c) Space available in the vehicle d) Amount of torque to be transmitted
Why oil is mixed with coolant and what are causes of this?
What are sliding contact bearings?
How much diesel does 1000 kva rating dg set at full load consume?
The resistance to the vehicle motion whose magnitude remain constant with respect to the vehicle speed is a) Resistance due to gradient b) Resistance due to the road c) Resistance due to the tyre friction d) all of the above
Why oil with petrol can be used in two stroke engines but not in four stroke engines (two wheelers)?
What is the allowable -ve carnkacse pressure (vacuum) in the gas engine of 1.5 MW, what are the reasons and how it can effect the operation of the engine?
Is boiler a closed system?
What is an injector pressure in heavy vehicles?
If two shafts used for transfer of drive are inclined to each other, then a) Slip joint is used b) Flange coupling is used c) Universal joint is used d) None of the above
What do you understand by ductile-brittle transition temperature?
Can servomotor be used for applying torque or load to the gear box drive shaft at various speeds for gear box testing purpose.
Slip joints are provided in the propeller shaft a) To adjust the inclination of the propeller shaft b) To adjust the length of the propeller shaft c) To prevent the whirling of the propeller shaft d) To adjust the up and down movement of the rear axle
Which would you use - hydraulics or pneumatics?
What is the size of the recommended compressor cfm? Where it can be used?
